Data sheet

HSS-G Co 5 centre drill DIN 333, 2,5x6,3mm
Item number:
BOHR ZB 2,5 HSSCO
Example illustration
Item description
Description:
Right-hand cutting centre drill, form A, countersink angle 60°, surface bright, for producing centre holes according to DIN 332-1, form A (without protection countersink)
Qualities:
HSS-G:
Use for steel, cast steel alloyed and unalloyed (<800 N/mm² tensile strength), grey, malleable, nodular and die cast iron, sintered iron, nickel silver, graphite, short-chipping aluminium alloys, brass, bronze and plastics.
HSS-G Co 5 (HSS-E):
Use for steel, cast steel alloyed and unalloyed (<1300 N/mm² tensile strength), grey, malleable, nodular and die cast iron, sintered iron, nickel silver, graphite, short-chipping aluminium alloys, brass, bronze and plastics. Can also be used for hot and cold work steels, as well as rust and acid resistant steels (stainless steels V2A / V4A).
Properties
Qual­ity HSS-G Co 5
Ver­sion Sin­gle cen­tre drill
Di­am­e­ter [mm] 2,5
Shaft di­am­e­ter [mm] 6,3
Total length [mm] 45
Further information:
Weight 6,6 g / pcs
GTIN 4050571923495
Customs duty number 82075060
RoHS compliant Yes
More information on this item and the process for ordering it can be found in our online shop https://www.landefeld.de under item number BOHR ZB 2,5 HSSCO.
Landefeld Druckluft und Hydraulik GmbH · Konrad-Zuse-Straße 1 · 34123 Kassel · Germany
All data are to be understood as non-binding reference values! We do not assume liability for any data selection not confirmed in writing. Unless otherwise specified, pressure values refer to liquids from Group II at +20°C.
As of: 21.06.2025