Please wait, check is in process...
Body and sleeve: polypropylene, threaded part: polypropylene or stainless steel AISI 304, cartridge: stainless steel AISI 304, seals: EPDM with PTFE coating (cylindrical thread with captive EPDM O-ring), holding claws: stainless steel AISI 301, plastics and seals used are FDA approved (only silicone-free seals and lubricants are used during assembly)
-20°C bis +80°C
-0.95 to 9 bar (up to max. +20°C), 30°C: 6 bar, 40°C: 5 bar, 50°C: 4 bar, 60°C: 3.4 bar, 80°C: 3 bar. No pressure reductions for types IQSG ... PP ES, IQSF ... PP ES & IQSS ... PP ES.
Unoiled compressed air, water (also demineralised), harmless gases and liquids (no mineral oils)
Due to the mechanical properties of the material polypropylene, the push in fittings should not be exposed to any increased mechanical loads. Return of opened packaging is excluded.
•Easier to use and more economical than push-in fittings made of stainless steel, •resistant to hydrolysis, •cleaned, assembled and individually packaged in clean room (US FED 209D, class 10000 - ISO 14664-1 class 7), •manufactured without oil and silicone, •threaded pieces made of polypropylene or stainless steel, •transparent body makes it possible to see the medium inside the connection, •the plastics and seals used are FDA approved
Early ordering service
You will receive an additional 1% discount on your entire order within the next
Late ordering service
Shipping on request is still available today if you order within the next